RAILING LENGTH MEASUREMENT / 1

ograda_1_1301416230.JPG

Move the fenders and all other objects that could hinder the measurement.

RAILING LENGTH MEASUREMENT / 2

ograda_2_1301416321.JPG

Set the meter starting point on the force transmission point (the place where the terminal bolt touches the railing).

RAILING LENGTH MEASUREMENT / 3

ograda_3_1301417179.JPG

Pull the tape measure along the wire corresponding with the wire position on board.

RAILING LENGTH MEASUREMENT / 4

ograda_4_1301417319.JPG

Make sure that the meter and the wire being measured are on the same height.

RAILING LENGTH MEASUREMENT / 5

ograda_5_1301417622.JPG

Measure the length to the force transmission point (9,11 m).

RAILING LENGTH MEASUREMENT / 6

ograda_6_1301417658.JPG

Return the fenders on the previous position.

RAILING LENGTH MEASUREMENT / The procedure for railing length measurement

  1. Move the fenders and all other objects that could hinder the measurement.
  2. Set the meter starting point on the force transmission point (the place where the terminal bolt touches the railing).
  3. Pull the tape measure along the wire corresponding with the wire position on board.
  4. Make sure that the meter and the wire being measured are on the same height.
  5. Measure the length to the force transmission point (9,11 m).
  6. Return the fenders on the previous position.

If there are no railing and columns, approximate the meter position to the supposed wire position.
If the standard adjuster is used, the permissible error is till 2 cm.When using the pelican hook instead of adjuster, the permissible error is 1 cm.You should send us these measurements, as well as the diameter and the wire type (or boat type) and we'll submit you our offer.
Similarly, the measures for the mast wires are taken, but please contact us before.

 

"SKIPER"
Grgura Budislavića 99
HR-23000 Zadar
e: skiper.zadar@gmail.com
mob: ++385/(0)95 837 4749
mob: ++385/(0)95 894 5889